Accessories for chassis and running gear
Lifting axles have automatically load-dependent reaction. In this way you can reduce your tyre wear and save fuel.
Skid shoes protect the underrun protection from damage in case of ground contact at the rear.
The spare wheel is stored in the centre. The easily accessible screw connection also allows securing of a wheel rim.
Due to the low height of the Mega Liner, the spare wheel bracket is executed as a winch and is easily accessible.
The IVTM tyre pressure monitoring system reports any deviation in the set tyre pressure directly to a display fitted in the driver's cab.
The SAF TIRE PILOT permanently checks the set tyre pressure and, if necessary, inflates the tyre.
You can calculate the effective mileage of your vehicle using the axle cap odometer. This is independent of the truck.
A rear, stowable leg and crank can be used for additional support during loading and unloading on the ramp.
High strength ferry rings secure the vehicle in ferry traffic.
An optional spray suppressor minimises rear water spray for following traffic.
Additional air connections are also available for international traffic with changing tractor units (here: DANA C).
The Duomatic quick coupler allows fast and uncomplicated air line coupling.
An additional work light below the chassis on the side makes work easier when visibility is poor.
A yellow beacon and pull-out warning sign warns other road users, for example, when transporting wide loads.
Modern reversing aid such as, e.g. Soft Docking or Tailguard helps you to prevent damage during docking at the ramp.
A brake monitor gives information about the status of the brake linings.
What applies to tail lifts applies to the holder for the transportable forklift as well. Mounting fixture for all conventional transportable forklifts is available.
Tail lifts of different manufacturers, in upright or foldable design, are available. Naturally, the platform can also be designed for the later installation of a loading platform.